ここから本文です
TWO:For milling, drilling or boring ordinary work within its range, a lathe is by no means a makeshift tool, but performs these various operations with nearly all the advantages of machines adapted to each purpose. An ingenious workman who understands the adaptation of a modern engine lathe can make almost any kind of light machinery without other tools, except for planing, and may even perform planing when the surfaces are not too large; in this way machinery can be made at an expense not much greater than if a full equipment of different tools is employed. This of course can only be when no division of labour is required, and when one man is to perform all the several processes of turning, drilling, and so on.
Classification by type of system
1natural circulation external heating pipe type
2natural circulation calandria type
3forced circulation type
4falling-film type
5rising film type
6jacket type
7coil type
Classification by method of operation
1single effect evaporator system
2multiple effect evaporator system
3auto-vapor mechanical compression system
4auto-vapor ejector compression system
5multistage flash system

After taking into consideration of the physical and chemical property of solutions, the desired design conditions, and available utilities, we select the most suitable type of system by utilizing our years of experience and excellent results.
In addition, we can offer designs and manufacturing services that take into careful consideration compactness, energy-efficiency, and automatization.

THREE:If asked for advice as to the most important object for an apprentice to aim at in beginning his fitting course, nine out of ten experienced men will say, "to do work well." As power is measured by force and velocity, work is measured by the two conditions of skill and time. The first consideration being, how well a thing may be done, and secondly, in how short a time may it be performed; the skill spent on a piece of work is the measure of its worth; if work is badly executed, it makes no difference how short the time of performance has been; this can add nothing to the value of what is done although the expense is diminished.

While standard calandria type evaporation systems are widely used as the typical concentration evaporator by the various food and chemical industries, we have delivered many of those systems as finishing concentration evaporators especially for sugar solutions and starch syrups.

THREE:"Why not?"
  • Enables flexible operation with little influence from variations in load and raw solution concentrations because of an adequate amount of solution being held within the system. These systems are also suitable for batch type burning evaporators.
  • Concentrations can be controlled within product specifications by the cascade control using the concentrations of concentrated solution and the raw solution supply and also by the arithmetic control of raw solution concentrations, etc. (Result for sugar solutions: 75±0.2wt%)
  • High-viscosity solutions and solutions that may crystallize can also be utilized by installing a propeller in the evaporator as a forced circulation system.
THREE:In this class belong

This is a process example of a device that continuously and simultaneously concentrates two types of waste liquid with a single high-efficiency steam compressor.

THREE:As remarked in the case of other machines treated of, there is no use of describing the mechanism of trip-hammers; it is presumed that every engineer apprentice has seen trip-hammers, or can do so; and the plan here is to deal especially with what he cannot see, and would not be likely to learn by casual observation.I.
  • By evaporating the steam using a mechanical compressor and reusing it, almost no heating steam is alomost required except the time of start-up, so large energy savings can be expected.
  • By combining with a thin film falling heat exchanger that does not raise the boiling point due to the liquid depth, it is possible to utilize the temperature difference of the compressor at the maximum.
  • Since the residence time and heating time are short and the holding amount is small, starting and stopping can be performed in a short time.
  • It will prevent scale adhesion in the can that the evaporator is divided into two parts, and that the supply of the undiluted solution is alternately switched over a fixed period of time to perform heat concentration.